「錦州快速門」堆積門儲備電源接線圖



Connection Diagram of Reserve Power Supply for "Jinzhou Express Gate" Accumulated Gate

為了避免用戶在停電的狀態下無法迅速的打開和關閉快速門，北京龍盛門業的每一個工程都標配專用儲備電源一套。



In order to avoid the users can not quickly open and close the fast door in the state of power outage, each project of Beijing Longshengmen Industry is equipped with a set of special reserve power supply.



這樣，一旦斷電，用戶可通過專用的備用電源，運行快速門15個回合。



In this way, once the power is cut off, the user can run 15 rounds of the fast door through a dedicated backup power supply.



避免出現火災等危險情況無法迅速關門阻隔或開門逃生。



Avoid dangerous situations such as fire, and can not quickly close the door to block or open the door to escape.



「錦州快速門」堆積門儲備電源接線圖



Connection Diagram of Reserve Power Supply for "Jinzhou Express Gate" Accumulated Gate



對于該儲備電源的一些相關參數，我們之前的文章已經有過介紹了



Some parameters of the reserve power supply have been introduced in our previous articles.



今天的文章，我們將要為您分享測是它的使用和接線方法。



In today's article, we will share with you the usage and wiring methods of measurement.

安裝操作說明




Installation instructions



1、 請按照推薦安裝方式接線安裝，進風口和出風口最小 10 厘米內不能有障礙物。



1. Please connect and install according to the recommended installation mode. No obstruction can be found in the minimum 10 cm of the air inlet and outlet.



2、 打開面板開關，按啟動按鈕或外接啟動按鈕，后備電源進入逆變工作模式。



2. Open the panel switch, press the start button or the external start button, and the backup power supply enters the inverting mode.



3、 市電輸入接通市電，后備電源進入市電模式，停電時后備電源自動轉換逆變模式。



3. The municipal power input is connected to the municipal power supply, the backup power supply enters the municipal power supply mode, and the backup power supply automatically converts to the inverted mode when the power failure occurs.



4、 停電后開門觸點閉合，如果開門觸點連接快速門開門接點門將打開，開門后空載 20 秒關機，如果還要繼續使用備用電源按啟動按鈕或外接啟動按鈕。



4. The open contact closes after power failure. If the open contact connects with the fast door, the open contact door will open. After opening the door, shut down without load for 20 seconds. If you want to continue using the standby power supply, press the start button or the external start button.

注意：




Be careful:



*請勿自選拆開機蓋，內有高壓危險!如有問題請與我司技術部聯系。



* Do not open the cover of the machine optionally. There is high pressure danger in it. If you have any questions, please contact our technical department.



*機器使用時需保持通風良好。



* Maintain good ventilation when using the machine.